GE Monogram Trash Compactor ZCGP150PII User Manual

ZCGP150PII - GE Monogram^™15" Built-In Compactor for Custom Panels

Dimensions and Installation Information (in inches)

This compactor is designed as a built-in appliance

only. It may be located in any convenient space

under a countertop.

Front View (not to scale)

DO NOT OPERATE FREE-STANDING because the compactor

will tip over when the drawer is pulled out.

Additional Specifications: A 115 Volt, 60 Hz. power supply

is required. An individual properly grounded branch circuit

protected by a 15- or 20-amp circuit breaker or time delay

fuse is recommended. Install a properly grounded 3-prong

electrical receptacle recessed into the back wall. Electrical

outlet location is critical for proper cord storage when

compactor is installed.

If the compactor is to be located in or near a corner of base

cabinets, allow 6” minimum clearance from the corner for

bag removal on the right side.

3/4"

Thick

Custom

Panel

29-3/8"

15"

For answers to your Monogram,^®GE Profile^™or

GE^®appliance questions, visit our website at

ge.com or call GE Answer Center^®service,

800.626.2000.

Listed by

Underwriters

Laboratories

Specification Created 9/08

160009